![]() Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.ģV2032 Lithium battery. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. THERE ARE NO OTHER USER SERVICEABLE PARTS. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. If battery is swallowed, immediately notify doctor.NEVER allow small children near batteries.To prevent possible SERIOUS INJURY or DEATH: ![]() Insert new batteries positive side up (+). To replace the batteries, remove the two screws and the logic board from the plastic housing, as shown. The lithium batteries should produce power for up to 5 years. Position bottom of door control on screw head and slideĭown to secure.(3 mm) to protrude above the wall surface. Drill pilot holes and install bottom screw, allowing 1/8".Fasten with 6ABx1-1/4" self-tapping screws as follows: Remove the push button cover by gently prying off the top edge with a screwdriver. NOTE: Locate the door control within sight of the door at a minimum height of 5' (1.5 m) where small children cannot reach and away from all moving parts of the door and door hardware. Permit anyone to cross path of closing garage door.Īnd universal receivers that have a purple “learn” button. ALWAYS keep garage door in sight until completely closed.Activate door ONLY when it can be seen clearly, is properly adjustedĪnd there are no obstructions to door travel.NEVER permit children to operate or play with door control push. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |